News

AL4 automatic transmission will cause the failure of the joystick to be pulled out of the P gear. When the other gears are not connected, the driver will be very annoyed if the car can not move. Of course, it is of no use to drive a joystick with a hard hand. An ingenious method of pulling the joystick: how to extend the service life of the engine to the engine's turbocharged intake system of the engine and introduce the input and output line of the short connection brake light switch; insert the lock stopper into the lock and unplug the electromagnet with a large screwdriver. Pull out the operating lever quickly, disassemble the central glove box, pull the armature core of the lock driver directly, and pull the shift lever to the "N" gear. Of course, there is a premise to eliminate this fault, that is, the brake lights are not effective after stepping on the brake pedal. If the "SPT" and "*" lights flashing on the dashboard may be the damage of the automatic transmission computer or the protection of the starting relay, it is not possible to use the above method to pull the transmission lever. In addition to the design reasons, the gas resistance will occur in the oil tank and the oil pipe near the high temperature area. The traditional cooling method of cold water and cold cloth will be eliminated. Other electronic fuel injection vehicles will also produce air resistance, such as Fukang electric vehicle suddenly extinguished in the road, can not start again. At this time, we should open the electric door, start several times, use the oil basin to catch the disassembled car filter outlet oil, until the bubble gas is discharged, tighten the oil pipe. At the same time, it will tell you, don't press the white button in the tank, and fill the tank with oil, so that the gas tank is not discharged. This kind of fault is most likely to occur in a full tank taxi. Fukang car is speeding in rainstorm and prone to flooding. The reason is that the suction port is located in the front and bottom of the water tank mask. The splashing mud is easy to suck the cylinder from the suction port through the air filter, resulting in flooding the cylinder and damaging the cylinder block. At the same time, due to the structural characteristics of Fukang car in the northern part of the dust storm, the dust is also easy to enter the air filter from the suction port and cause blockage and flameout. In sandstorm weather, dust removal from air filter element should be cleaned frequently, and the suction port can also be turned to side effectively. In heavy rain days, we should control the speed and choose the road surface and not flood the pool. If the rainstorm is persistent, simply remove the suction pipe from the end of the air filter and install it after the fine weather. It can effectively avoid the accident of flooding and tamping.